Review on 🚘 Enhance Your Jeep Wrangler TJ with u-Box White DRL Turn Signals w/ Amber LEDs for 1997-2006 Model by Nicholas Peters

I installed on a 2004 Jeep TJ. The lights came quickly and work as advertised. They do not work on a "plug and play" basis as there is no wiring harness attached to the light that could be connected to a vehicle mounted wiring harness. Therefore, you will need to insert the wires into the slots previously occupied by the blades protruding from the connector attached to the stock turn signal. I wired up the .110 pin breakers I bought from Revain because the three stores I visited only had female breakers for reasons unknown. At first I tried to insert the wires into the slots as finely as possible, but that didn't work very well and was very disappointing. The box had instructions with lots of color pictures, but otherwise it was unusable. I take it back. I used wire glue to hold the wires in the breakers and it worked fine for my workbench. The wiring uses a resistor that came with the headlights. The instructions were completely wrong and when I followed them they just flashed white and not amber. Luckily someone posted a video on the product page here on Revain. YOU MUST WATCH THE VIDEO FOR CORRECT INSTALLATION. This minute is long and important. I only gave four starts because the install instructions were useless and just plain wrong. TL; DR: The product is good but you need to watch the video posted on the Revain product page to connect properly as the instructions included are incorrect.