1 Level
795 Review
57 Karma
Review on WINSINN Cooling 50X50X15Mm Extruder Makerbot by John Stowers
The fans work well and are not noisy
I bought them for my 3D printer to cool the stepper motors and the hot end for the cooling duct of Hero Me 5. Fit perfectly and the installation was simple, just connecting two wires. The noise level is very acceptable but then again my printer is in a garage with an enclosure so your experience may vary.
Pros
- Stylish and modern design
Cons
- Some difficulties
New products
Comments (0)
Top products in ๐งฐ Computer Internal Components
Another interesting products
Comprehensive 500pcs Laptop Screw Kit Set for ๐ฉ IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
4.25
12 Review
M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
5
19 Review
Glarks 660 Pieces Phillips Assortment Motherboard
4.06
10 Review
36-Pack Black Rubber PC CPU/Case Fan Screws/Rivets Set for Computer
4.52
11 Review