Bore should be 5/8 inch. Instead of a hole, there was a whopping 1 mm for a small one. In addition, the keyway was too small in both width and depth. Now a kicker, the keyway has been cut down the middle, leaving one side lower than the other. I saved the best for last, the length of the keyway was cut diagonally to a square. How does someone do that? In the end it's pure crap. Well to be fair it might just be my bad luck but everything else is fine. Much luck!
🔧 Tsubaki 35B15F 1 Finished Sprocket Single: Premium Quality Sprocket for Maximum Efficiency
3 Review
High-Quality Roller 🔗 Chain Sprocket Teeth Replacement
3 Review
🔝 High-Quality 40 41 420 Chain Sprocket for Optimal Performance
3 Review
🔀 High-performance Centrifugal Clutch with Tooth Chain Power Transmission Products
3 Review
Xiaomi Air 2 Pro Wireless Headphones, Black
86 Review
Electric Guitar Strings Ernie Ball 2221 Regular Slinky - (10-46)
5 Review
🔧 High-Quality TIMKEN 6203 2RSC3 6203 2RS Bearing - Size: 17X40X12mm
4 Review
👜 Wheels Manufacturing Ball Retainer Bag: Convenient Storage and Protection for Your Ball Retainers
6 Review