I used two SDRs to build Stratux. To install two units side by side you must remove the plastic covers. Easy enough to pry with a sharp blade. Remember to mark each block 1090 or 978. Each block is wrapped with a layer of Kapton (polyamide) tape for electrical insulation and heat dissipation. These devices must draw the maximum current allowed by the USB 2.0 port and then some. Would have given 5 stars if the devices hadn't gotten so damn hot. Luckily, the case I'm using has a small fan for the USB accessory, which at least keeps the end connectors touchable. The cable assemblies are sized to fit inside the case and attach to the antennas. Most importantly, I get good 5nm sensitivity from the MCC. It was not possible to test in the air.
π» Enhanced NESDR SMArTee v2 Bundle - Top-Notch RTL-SDR with Built-in Bias Tee, Sturdy Aluminum Enclosure, 0.5PPM TCXO, SMA Input Port, Antenna Base & Trio of Antennas. RTL2832U & R820T2-Based Software Defined Radio (SDR)
10 Review
π NooElec NESDR Smart XTR Bundle - Premium RTL-SDR with Extended Tuning Range, Durable Aluminum Enclosure, Ultra-Precise 0.5PPM TCXO, SMA Input
9 Review
π°οΈ NooElec SAWbird+ GOES - Enhanced Saw Filter & Ultra-Low Noise LNA Module for NOAA (GOES/LRIT/HRIT/HRPT) Applications. 1688MHz Central Frequency
9 Review
π» NESDR SMArTee v2 SDR - Premium RTL-SDR with Integrated Bias Tee, Aluminum Enclosure, 0.5PPM TCXO, SMA Input: Unleash the Power of Software-Defined Radio
10 Review