Header banner
Revain logoHome Page
computer case deepcool matrexx 55 black logo

Computer case Deepcool Matrexx 55 black Review

55

·

Very good

Revainrating 4.5 out of 5  
Rating 
4.5
Computers, ⌨️ Computer External Components, 🎒 Computer Cases, ⌨️ Computer External Components

View on AmazonView on ЯM

Media

(10)
img 1 attached to Computer case Deepcool Matrexx 55 black
img 2 attached to Computer case Deepcool Matrexx 55 black
img 3 attached to Computer case Deepcool Matrexx 55 black
img 4 attached to Computer case Deepcool Matrexx 55 black

Photos by authors

(21)
img 11 attached to Computer case Deepcool Matrexx 55 black
img 12 attached to Computer case Deepcool Matrexx 55 black
img 13 attached to Computer case Deepcool Matrexx 55 black
img 14 attached to Computer case Deepcool Matrexx 55 black

Description of Computer case Deepcool Matrexx 55 black

Full-length 4mm thick tempered glass side and front panels give the case a unique look and feel to perfectly showcase the internals. Optimized airflow management is provided by large air intakes on the front panel and air outlets on the rear and top panels to keep components cool.

Reviews

Global ratings 55
  • 5
    37
  • 4
    14
  • 3
    2
  • 2
    0
  • 1
    2

Type of review

Revainrating 4 out of 5

I have not regretted the purchase, everything is fine.

In general, the case really deserves attention, and I advise you to take it for 3 thousand, well, 3.5k maximum, but not more expensive - then you should look for more interesting solutions, from the same deep cool, matrexx 70, much more interesting, and even more a custom copy, which is actually an order of magnitude better than this case.

Pros
  • - Appearance, it is beautiful, without further ado - Tempered glass front and side - The most convenient installation of all components (except for the lack of a quick release for ssd, but we have a case for 3k, everything is perfect in this regard) - Ventilation at a sufficient level, there are no critical temperatures, up to 6 fans (I personally have 5), they fit perfectly both externally and in terms of cooling - There is no lack of a casing over the power supply, but thus it gives quick access to replacing it and replacing hard drives (yes, it's really convenient, believe me, it's better to remove the glass than to remove the back cover)
Cons
  • - Gaps. I don't know how, I don't know why, but I have gaps almost everywhere. The front panel has a paper-wide gap at the top and side, and light comes out perfectly through it (yes, a nitpick on manufacturing, and I just got unlucky, but still) - CURVED side glass. From this I fell into a slump. And no, this is not a curved body, and not curved fasteners, it is really curved glass (again, apparently not unlucky, everything is fine with the same repairman), which SHOULD NOT be like that. But, in defense, I can say that this only causes inconvenience morally and a little more in the case when you twist the glass back - you should start with the top "screws", if you can call them that, and then everything will be fine - Squeaky legs. I don’t know how and why, but it’s on my linoleum that nothing creaks, except for the legs of this case. And even the car soundproofing in the form of a pile, which I pasted on each of the legs, did not really save the situation, but still helped. Again, you will most likely move the body infrequently, or even put it on the table, where it will stand and shine. - Backlight controller. Yes, it is, and in the same review of the Repairman it was said that you can connect RGB switching to it and everything will be okay - xs where is there even a hint of connectors on the board, but at least they are simply not soldered there, there is and is calculated on the board place for them.

Revainrating 5 out of 5

I definitely recommend buying, I didnt notice any disadvantages.

to turn on the backlight, you need to insert a 4-pin backlight connector (male) into the power supply (mother) there is such a backlight connector that feeds hard drives, if the backlight button flickers red and it annoys you, then you need to disconnect the disc indication cable

Pros
  • thick metal, tempered glass.
Cons
  • if you have a cheap ssd or a power supply with tight wires, then you won’t normally install an ssd, you have to install it like in my picture.

Revainrating 4 out of 5

I like the product, the quality did not disappoint.

It is quite possible to take the case, but it is better to throw it on the 70 matrix I didn’t go through a lot of bakery, everything fit))

Pros
  • Quite beautiful, heavy, and not a knick-knack 2 kilograms, 2 glasses, without a bp casing. You can think of good cooling, the iron is cold, despite the fact that the front end of the deaf air enters the body with slots. It looks better in the eyes for some reason)))
Cons
  • For top-end power supplies, there is little room for cables, somehow I inserted them, 140 Artiks didn’t stand on the front, the cover flies back, so they stand inside the case, + fix some kind of hell on the bottom cooler .

Revainrating 4 out of 5

The product is really good, I'm glad I purchased it.

Very good for the money, but it's worth considering the cooling system and not skimping on cabinets, because there are no significant large holes (the top cream for the radiator / housings). I would still recommend the version with the perforated front panel rather than the glass one

Pros
  • A lot of space. You can literally cover yourself with case fans (accommodates 6 120mm fans, or 2 places for large radiators. Enough space for aesthetic rowing with wires (lots of space, lots of holes, you can crawl up to everything) Price. (still, for such money, a case with a glass panel, with an acceptable quality of materials)
Cons
  • Slots for disks. First: there are only 2 of them under the HDD. Second: there are no vibration pads. A cascade of pawls for case fans with a non-standard connector (because of which case fans are plugged into the mother by default). Dust protection purely theoretical

Revainrating 4 out of 5

Reliable product for all occasions, quality on par.

The case is heavy, mive, but very durable. I'm building a PC for the first time, so I'm very pleased with the purchase, but in the future I'm unlikely to take cases of a similar type, I need to look for something more breathable.

Pros
  • Tempered gl Good build quality Slides for discs Great room for action VERY nice looking
Cons
  • Dust filters are , in fact they don’t perform their function, you can safely throw it away and look for something normal to replace it. The front panel is suffocating, stands on blowing 3 140 mm fans (yes, it is POSSIBLE to put them there, no matter what anyone says), but in fact the flow is very weak Personally, I have a backlight control on on the case that constantly turns on and off. That red flash is annoying.

Revainrating 5 out of 5

The best I ever used, recommend it to everybody.

I am very pleased with the appearance, it is a pity that while it is standing under the table, it will soon move to the table, since you want to look at such a case and get aesthetic pleasure. For a strong fixation of the lower fan on the front wall, I ordered silicone screws.

Pros
  • Design, room for cables between the board mounting sheet and the removable wall, the wall itself is flat and without bulges like on cheap cases. "Blow" is excellent.
Cons
  • It is not convenient to fix the fan (with screws) on the front wall, the one on the bottom, as the non-removable hard drive cage interferes. Didn't find a speaker in the kit.

Revainrating 5 out of 5

Full compliance with the manufacturers assurances, high quality.

Guys, the front cover snaps off easily. From below, pull towards you and voila, install the front fans. And then many simply cannot open the instructions, everything is written there. And yet, on the front you have two choices: three 120mm fans, or two 140mm fans. I set 2 to 140, because if you set three, then the bottom fan blows into the HDD bay, I see little sense from this.

Pros
  • Really big. There is plenty of room for wires in the back. There is a sled for HHD. Draws in little dust.
Cons
  • Power supply from below. It up all the dust. There is an anti-dust mesh, which needs to be cleaned once a month.

Revainrating 5 out of 5

Great product, best quality.

Fully corresponds to the ratio of price and quality Has some pros: Great and spacious building. Assembles easily and with pleasure. All wires are compactly placed under the side cover. Has some cons: I still don’t understand why you need a MAIN cable from the front panel, and without it everything works

Revainrating 5 out of 5

Perfect product for any user!

Pros below: A clear system manager, the whole village is perfect, I really liked the appearance of both the outside and the inside. Good airflow, the system does not heat up from the word at all. Take no doubt! Has some cons: From above, the grid on magnets could be fixed better, otherwise when I put my feet on the system unit, it moves out) no longer revealed.

Revainrating 5 out of 5

The best product, from those that I have viewed, I advise everyone!

Please note there are no coolers, so you can immediately order them, they brought me one delivery (3 in front, two on top, one in the back)

Pros
  • Well packed, all the screws are there, there are no dents or scratches, all the glass is in the film, the metal is good, the side is glass (not plastic)
Cons
  • You will sweat to fix the lower cooler in front)

Revainrating 5 out of 5

I definitely recommend buying, I didnt notice any disadvantages.

Has some pros: Places wagon. All wires are perfectly hidden behind the back wall. Beautiful. Its cons: The build quality, maybe I’m picking on it, of course, but the seal under the glass wall is glued on, well, it’s not neat at all and the most annoying thing is that you can see it .

Revainrating 5 out of 5

The best thing Ive ever used, a great item for everyone!

Changed the backlight. Now a pure green glow. Once again I pressed the controller button (displayed on the top wall) - now the backlight is red. With its pros: Appearance of the system unit after assembly. Installed fans inside the case. A place for the power supply and a way of breeding wires inside the case. Special insert with LED strip between the body parts. Button backlight control. Has some cons: For now - one of the best deals for a bright gaming computer home.

Revainrating 5 out of 5

I am amazed! It was definitely worth the money!

Has some pros: Execution quality. Large volume for cables. Places for 4 140 or 5 120 fans. Strict appearance. High legs. Lots of space inside. You can have a long video card and a tower. Its cons: RGB backlighting is an extra pampering. I didn’t even connect, I don’t want to.

Revainrating 5 out of 5

A wonderful product, its nice to use.

Today, sharing my review.Got pros: The body is large. Is there a place to hide unnecessary wires? With its cons: Ssd is a very inconvenient connection. Small wire window

Revainrating 4 out of 5

I'm satisfied, the product is exactly as described.

In general, a good case. Took for a dual-processor machine. The case immediately began to heat up terribly due to poor ventilation, now I work without a side panel. Case is cold. Fans ordered. While the case was waiting, until the last moment there was hope that the front panel would open. For 4K this is the best option.

Pros
  • Compact, lots of space inside, beautiful appearance
Cons
  • Requires cooling fans. Only 2 disks can be installed. The front panel does not open. Only one removable cover for PCI slots on the rear panel.

Revainrating 5 out of 5

The best thing Ive ever used, a great item for everyone!

I am very pleased with the purchase, I use it for a very long time, there is little dust in the case and it is convenient to clean.

Pros
  • Quality glass, lots of space for wires, excellent equipment. And bright lighting.
Cons
  • There is not

Revainrating 5 out of 5

Satisfied with the purchase one hundred percent, I recommend the product for everyone.

In everything else, I liked everything. I really liked the minimal illumination, because I do not like "Christmas tree garlands". I also liked the large space on the side for laying wires. I definitely recommend the case. Nothing extra, no frills. Everything is simple and strict. Has pros: Only pros, pros and more pros! . but not exactly in my case. Its cons: Why does no one in the reviews write that in this case on the front panel behind the glass there is a metal plug for additional…

Revainrating 5 out of 5

A really necessary purchase, Im glad I found this product.

For a VERY long time I was looking for a case for the ASUS Z9PE-D16-10G/DUAL server board due to the unusual location of the fasteners. And then I accidentally came across this case and for an adequate price tag! Below is a photo of how I adjusted the mounting scheme according to the pictures)

Pros
  • - Sleek, stylish design - A large number of brackets for the motherboard (! ), you can even put perverted server boards - Plenty of room for cables - Flexible options for installing fans
Cons
  • In the front glass panel there is no possibility for installing peripherals such as a DVD drive or a card reader, although inside the case, it seems, there is one place on top.