Review on 📱 (6-Pack) RinoGear Apple Watch 40mm Screen Protector - Full Coverage Clear Film for Series 6, 5, 4, SE - Case Friendly iWatch Accessory by Linda Nelson

the adhesive on the protective film is not bad but does not stay put when something is stuck to it, grocery bags, when you reach for things the protective film comes off That's how it got slightly exposed to the influence of the dial, which I tried to protect with this particular product. (My reason for the lower rating) PRODUCT SPECS: There is a process to install this screen on an Apple Watch. STEPS: - Make a solvent in a coffee mug or mug made with a small amount of dish soap and room temperature water - Submerge the screen in water and allow the water to drip off the screen (make sure your fingers are wet to avoid leaving fingerprints ) - place it on the watch (sticky side on the watch) and let it sit for 30 minutes - go back, fold the sides and gently press the screen protector again - after that it will be for a few hours to take root and you may have to press the sides again. or something [THIS IS ALSO ON VIDEO VIA QR CODE PROVIDED WITH THE PRODUCT] It works but the quality of the screen protector makes me doubt here. From time to time it bubbled up, tangled on things as I worked day to day, and things tangled underneath. After swapping between 3 of the 6 screen protectors I tried adding a case to them and that seems to have relatively solved this possible problem. Although I've come to the conclusion that it no longer looks as nice as I'd like and got another watch case with a protective screen. Also for me was a much simpler solution. It was "Hardcover with Ultra Thin Tempered Glass Protective Bumper for iWatch" as stated on the label. But in the end it comes down to preference.