Header banner
Revain logoHome Page
Jerry Mills photo
Peru, Lima
1 Level
730 Review
49 Karma

Review on 🔧 Builder's Best 84049 SAF-T-Duct Zero Dryer Vent Periscope, Adjustable Length 0-5 inches, 4" Diameter x 8 feet, Aluminum by Jerry Mills

Revainrating 5 out of 5

Works as intended: Dryer parts and accessories

Worked fine for me. Installation is a little tedious, but that depends more on usage than the product itself. I have a very small gap between my dryer and the wall where the vent is. Using a flexible hose wasn't the best option as I had to compact it heavily. This product works well in tight spaces. The vent and dryer were only an inch away, but this product fit a lot better and was more durable than cramming a standard vent tube into such a small space. TWO THINGS YOU NEED TO MAKE INSTALLATION EASIER: Thermal tape (available at Revain for $5-6). Flexible bit extension for your drill or electric screwdriver - this makes it easier to access the dryer once it's in place to tighten the clamps. As I said, the installation was a bit annoying. but that's because I work in such a limited space. My best bet was to measure it according to the instructions and then freely test it to make sure it fits. Once I got the right size I cut it off. excess material and then sealed everything with THERMOFOIL TAPE. {You must purchase a piece of this tape to make it airtight and work effectively. Это не недостаток, это просто реальность того, как продукт должен быть регулируется перед установкой.) После того, как все было готово к работе, я c сначала подключил его к моей сушилке, пока он еще был вытащен, и у меня было место для работы with him. I twisted the clamp and fastened it securely. I then drew the outside vent and put the dryer back in place. I've found that it works best if I make 4 small cuts in the periscope vent outlet tube so I can fit it into the vent in the wall. It also helps if someone slowly slides the dryer into place while you push the periscope outlet into the opening in the wall. Once it was secure I used a cordless screwdriver with a flexible extension and end cap to get to the dryer and tighten the outlet clamp. It's not a quick and easy install, but it's doable for the average person - it just takes some patience and planning. And after installation it works fine.

Pros
  • Great design
Cons
  • Definitely bad product