Review on Universal Rear View Mirror Holder with 16 Joint Attachments for APEMAN, Falcon F170, Old Shark, Peztio, Rexing V1P, Roav, UGSHDI, Z-Edge & Most Car Dash Cameras by David Lambert

I have a Roav A0 DVR and I'm tired of the suction cup constantly falling off. I knew attaching it to my rearview mirror was best, but I needed one to work with my model. When I looked at this product, it turned out that it would work. When you first receive the parts pack, you may feel overwhelmed. NOT! This is just to install as many different cameras as possible. Luckily I didn't throw away my old Roav A0 sucker because I needed the lever, rod and collet nut from it because none of the levers that came with it fit in the cam mount slot. After installing those old parts back onto the DVR, all I had to do was use the bracket that came with the sphere. I fed the rod through the bracket and tightened it with a nut. Once that was done, I simply inserted the ball end of the mount into the mount and tightened. To mount the bracket to the rear view mirror bracket, I suggest tightening one wing nut first and then just letting it hang there before attempting to install the other wing nut. This saves you trouble. If you're ordering this, don't throw away your old dash cam suction cup or parts just yet. You may need some of these parts to make this holder work.