Review on Nilight 90020B Mounting Off Road Horizontal by Khalil Hopp

So I wanted to add lights to the Smittybilt bumper tubes on the back of my Jeep. It says it's 2" and the measurements are the same, but I've tried two other mounts before and neither of them worked immediately as a 2" mount. They are supposed to be 2.2" so I thought they would even out the coating on the tubes. What I thought was my problem. It wasn't quite like that. The bottom half of the brackets fit perfectly out of the box, the top half however they didn't. Each one was too tight at the bottom of the semi-circle which meant they didn't sit flush and couldn't be tightened. I was able to fix this in minutes with my dremel. It wasn't really difficult, and being aluminum , I wasn't worried about losing the plating. I let it sit well and everything worked as planned. The only minor issue was that one of the holes was covered with extra plating. I just had to take it out and clean it, and everything was fine. nothing special. i paired them with a couple of auxbeam cubes and i think they turned out well. in general i'm satisfied for the money and i think they look very nice.