Review on EchoMaster Wrangler JK Backup Camera Plug-and-Play Kit for MyGig Radios - Easy Installation with Touchscreen Interface & Reverse Lines (EM-BUC-KIT-JW) by Johnathan Delic

The system is easy to install and works very well after turning on the camera. Unfortunately, the instructions do not include the steps to turn on the camera! See below for correct connection instructions: 1) In step 6, connect the yellow and black RCA cables (female) to the yellow and black RCA cables on the extension cable. 2) Connect the yellow RCA (male) input of the extension cable to the yellow RCA (female) connector labeled Camera on the radio side of the harness. 3) Connect the red wire from your power strip to the red wire in the wire harness labeled Prog Output 1. Output 1 has a rubber grommet. You will need to remove or slide down the rubber bushing and crimp the connections with pliers. Then wrap the connection with electrical tape or put the rubber bushing back in place and tape it in place. (Do not use the blue wire listed as it is disabled by default!) 4) Connect the black wire of the extension cable to the black screw on the right side of the frame at the top right corner of the radio frame. this is your country Route the cable around the frame in the small notch and secure it with tape to prevent it from slipping out when reinstalling the radio. You can also use the black wire labeled "Output 2" as ground. When mounting the BCI-CH21, it is convenient to mount it to the right of the radio bezel in the dashboard. Use the velcro to mount it with the LEDs facing down so you can connect it to the app later if you want to add a camera or screens. Refer to the technical report for information on how to properly install the Wrangler. You'll need to flatten the metal clips so the camera sits flush. in the mountain!