This is for RPi4B. It didn't fit properly because the leg between the Ethernet port and the USB 3.0 ports was too long and was pressing against one of the chips on the board. After I shaved off about 1/8" it then sat down normally. Second, the fan didn't work on the 5V pin, only on the 3.3V power pin for some reason. Third, the instructions are almost useless Since the pics are too small to see what the correct parts are I only had a 50/50 chance of getting the fan lined up correctly and I guessed wrong board. Probably cut and glued from another Pi. That are fun little annoyances that were easily fixed.The only part of the guide that was useful was removing the frosted protective stickers from the transparent parts and pointing the fan screws in the right direction.After everything was assembled I tried the USB plug and the power plug and they fit well, I haven't tried the HDMI port but they look a bit recessed in the case so I'll have to check.
🌐 MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
LAFVIN Super Starter Kit for Arduino R3 Mega2560 Mega328 Nano with Detailed Tutorial - Compatible with Arduino IDE
11 Review
REXQualis Comprehensive Starter Kit with Arduino MEGA 2560 & Detailed Tutorial for Arduino IDE Compatibility
11 Review
🎁 Ultimate BBC Micro bit Sensor Starter Kit: Keyestudio 37-in-1 Box with Tutorial, Compatible with V1.5 & V2, Gift for Kids and Adults (Microbit Board Not Included)
11 Review
M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review
300Pcs Black Replacement Screws Kit for Lenovo Toshiba Gateway Samsung HP IBM Dell Sony Acer Asus Laptop Notebook Computer SSD Hard Disk SATA
5 Review
8Pcs Computer Thumb Screws Black
4 Review
💾 M.2 NVMe SSD Screws for Asus, Gigabyte, and MSI Motherboards - Laptop M.2 Screws
8 Review