Review on ASUS GTX 1050 Ti 4GB Phoenix Fan Edition Graphics Card (PH-GTX1050TI-4G) with DVI-D, HDMI, and DP 1.4 for Enhanced Gaming Performance by Mateusz Drabarczyk ᠌

The stock fan is buzzing at idle. 80 mm, high-speed, low. On your native program, you can’t set the revolutions less than 29%, as a result, 1650 rpm. When loaded with native furmark at 40 fps 1080p, the temperature was 74 degrees, the fan was like a turbine ((((. The situation was corrected by ing)) lay in the stash of a case fan from arctic cooling 8 pwm, on a hydraulic bearing, this company is famous for the noisy operation of turntables. I took a thin cross screwdriver, removed the original fan with the video card casing, disconnected the 4 pin connector, bit out the motor with the impeller from the case fan with side cutters, cleaned the end, degreased it and glued it to the regular place on the video card casing with 3M automotive tape, warming up the place of gluing with a lighter. video card (it is smaller than on the mother, but there are adapters for 60 on the Internet) if there is equipment, you can use the connector from the original fan, the main thing is not to confuse the wires, if you look at both 4 pin connectors from the mother and the vidyuhi with the key to yourself, the contact group located in the opposite order (1 contact of the connector from the mother will be the fourth on the vidyuhi), put the casing with the new fan back (the fan began to bulge out of the casing by 10 mm) So what could this achieve: firstly, silence, the fan is now inaudible))) idle speed is 1300, adhesive tape is like a vibration pad, and secondly, the temperature in the furmark dropped to 68 degrees at the same load. That is, the card has become colder, therefore it will last longer.