Review on 🖥️ Cooler Master MasterBox MCB-B600L-KANN-S00 ATX Mid-Tower with Stylish Brushed Design, Red Trim, & Acrylic Side Panel, MB600L Red Trim by Paul Walters

I am very disappointed with the cabling of this case. Heather only has one large connector that goes to the motherboard. But there are no pins for that on my motherboard. I was looking at another cooler master case I have similar to this one and lo and behold the large cable coming from the external USB 3.0 header has a small plug that comes out of the large plug so it fits in my boring one, it's not old at all. . I built it up completely, I have MS which makes it difficult for me to even turn the screw with a screwdriver. But I did it. Now I don't have an external front USB 3.0. I find this a very bad oversight in the wiring and very disappointing. I have to say that the case has rounded corners wherever the power supply is a nuisance and it could have been done a lot easier than other models. UPDATE: OCTOBER 3, 2019 I hated this case and once I get my parts out of the computer things will get better. 1. Mounting and location of the power supply stinks! A ridiculous decision to hide the PSU under some sort of metal attached to the case. Stupid decision! 2. I put a graphics card in, but the motherboard was so close to the back of the computer that there was NO room, NO room, to attach a metal strip to the back of my graphics card. I had to open the case to insert the card. But that's not all! The notches on the back of the case that allow the card to be used weren't so tight in the case that I couldn't easily pull them out. Why? Since the cooler Master put these weird protrusions in, I have bottom cutouts that prevented me from just pulling them straight out. I had to bend them, which took about an hour of fumbling, to get these knockouts out of the case. And why? Because the mainboard tabs press the mainboard against the back of the case. Whoever designed this case was far from correct. ok i'm done Don't buy this case!