Review on BIGTREETECH SKR Mini E3 V3.0 Control Board + TFT35 E3 V3.0.1 Graphic Smart Display Panel Board New Upgrade 3D Printer Parts For Ender 3, Ender3 Pro, Ender 3 V2 by Bryan King

It is my upgrade for ender 3 pro. It is good to upgrade from 8 bit to 32 bit. I cannot run klipper. (I use the stock LCD monitor. It turns to blue back light, full of black grids and no words shown. It may be my problem. I need more time to figure out. ) It works with marlin perfectly. I think the BL touch should be ok. I did not test much because I found that my z endstop has no response. Octoprint warns me a bl touch problem and it is not. For the hardware, I can print the BL touch holder. I have extra cables to extend the wires by 20cm and fit the stock setting.