Review on 🗄️ Accuride 1029 Center Mount Slide: Optimal Industrial Hardware Solution for Drawer Slides by Gregory Shorunov

This product is complete junk. The instructions don't even say how to screw a screw into the cabinet rail at the front edge. If you don't add a screw at this point, the rail will come all the way out of the rear bracket when the hood is pulled out. You also won't be able to fully seat the drawer unless you replace the above screw and the screw at the front end of the drawer with a pan head screw. The included pan head screws interlock when you squeeze the handle and prevent it from closing completely. Good luck trying to fit the front screw into the frame unless your drawer is screwdriver height, which is unlikely as you won't be able to insert that screw all the way leading to the same problem if both screw heads engage and don't to grab. the ability to completely close the box. After all, even after the extra screws you need and after spending about an hour of your life installing the rail, it doesn't run very smoothly. The ball bearing doesn't contribute to sliding at all, in fact I have older wheel guides from ten years ago that work much, much better. Don't waste your money or time. DO NOT buy this!