Review on 🖤 Black Carbon Fiber Chevy Bowtie Logo Wrap Kit - VViViD XPO (Set of 2 Rolls, 11.8 Inch x 4 Inch) by Troy Palmer

I would have preferred a cut, but these definitely fit. The black carbon fiber was exactly the pattern I wanted. It's a nice, nifty take on a truck, as I'm not the type to "offset the truck, bro." It's a sticky vinyl so luckily it will stick in place, then your wife's heat gun or blow dryer will do the rest and make it mold better to the object. What you'll need: - paper towels - rubbing alcohol - small razor blade or xacto knife - heat gun or hair dryer (emblems usually have a groove for cutting through) 4.) Smooth the edges after removing the excess vinyl. 5.) Use heat to shape/set the vinyl and gently hand smooth. Do not overdo the heat or you will shrink/melt the vinyl too much. If you screw something up, delete it and start over. You could probably also spray soapy water on the object's surface before applying it, but it takes more heat to "cure" the vinyl. You shouldn't have too many bubbles, this stuff works pretty well the first time.