Review on 📏 Get Accurate Measurements with the Johnson Level Tool RAS 120 Aluminum by Alfredo Testerman

Large workpieces require a large angle. Looks like a larger version of the frame square I had would be a good option. Not correct. The inner edge of the wider edge side of the triangle is not smooth enough before powder coating, leaving rough edges that prevent a smooth edge on the work piece. I didn't think it needed checking since the only purpose of a triangle is to be square. At a distance of less than 3 feet, the square will deviate by almost an inch. This is bad. It took me a few minutes to figure out what was going on because I never expected a square not to be a square. Very frustrating. Wouldn't buy this model again.