I was thinking plug and play, not even close. I had to solder a flat four pin connector into the wire. The length was acceptable for my 10ft platform but would have been too short for a boat trailer. Then, as if that wasn't annoying enough, the wire between the two taillights was less than four feet long, so too short to reach both sides of my 6-foot trailer. In addition, the light comes out "at the back". Left was right and right was left. Not that big of a deal, but it does mean you have to make a difference by doing the already-too-short, shorter GRRRRR. I like LEDs, but that's about it.
Адаптер проводки Nissan Brake Control Wiring Adapter: Tekonsha 3050-P - улучшен для бесшовной интеграции.
10 Review
🚚 MAXXHAUL 70094 12V Трейлерный комплект подсветки: идеальное решение для прицепов до 80 дюймов
10 Review
🧲 MUTUACTOR 2Pack 100lb Anti-Scratch Neodymium Rubber Coated Magnet: Versatile Magnetic Base for Off-Road Vehicle Lighting, LED Working/Signal Lights, Antenna, and More!
17 Review
Обновите соединение для автофургона с помощью LATCH.IT RV 7–6 комплект проводов для прицепа V2.0 — всепогодный, гибкий и простой в установке!
19 Review