Review on 19mm Latching Push Button Switch for Improved SEO by Brandon Gaines

So far so good. The LED wires are isolated from the switch pins and the LED glows at just 2.3V and less than 1mA in a lit room. I'm going to use LED wires with a 3.3V microcontroller output and it's what I would call perfectly bright at 3.3V. I don't see the full 1mA to 4V. At 12V I see i 7-8mA. The brightness in a daylight room doesn't change much after you raise the voltage above about 4V. At least in a room with daylight. Switch pins in different ways to show boot/switch status. They effectively drive the LEDs on the source inputs to switch, or on the load side, or in parallel. Look closely and you will see these connections. . In my case the switch state is not what I want. I want the other state represented by the LED (i.e. the load I'm driving is actually running) that this switch allows since the LED is separate.