Hose clamp overview. Works perfectly, but the instructions in the pictures leave a lot to be desired. Here are a few key points: πΉ There is a correct thread fit direction that MUST be placed in relation to the band or the screw will get stuck in the slot.? See attached photo. Note. I found that the correct direction was in the opposite curve of the roll of slit tape as it unwound. See attached photo of the tools I used. This makes it slightly easier to insert the slotted tape into the screw connection. πΉ After inserting the bent slit strap into the threaded joint, I found it helpful to use pliers to firmly grasp the slit strap into the threaded joint BEFORE bending the slit strap straight again. Using pliers will only make the fit tighter/flatter. See attached photo. Finally I would suggest doing a test run by inserting the slotted bar into the threaded joint and turning the screw about 8 turns to make sure there is no binding before actually installing it. With these adjustments, I found this product to work pretty well. .
6 Pack Miahart Adjustable 304 Stainless Steel 4 Inch Hose Clamp Duct 91Mm-114Mm Worm Gear Pipe Clamp For Automotive, Mechanical Agriculture.
18 Review
Vacuum cleaner Dreame V9 Global, white
145 Review
High-Quality QiiMii Stainless Steel Sanitary Clamp With Silicone Gasket - 2 Inch, Single Pin Tri Clover Design
16 Review
12V Brass Solenoid Valve, 3/4" Electric Air Valve For Water, Air, Gas, Fuel And Oil - Normally Closed By Beduan
10 Review