Review on 🐳 High-Flow Whale Gusher Titan Manual Bilge Pump for Boats over 40 Feet - Up to 28 GPM Flow Rate by Trey Ali

I purchased this plastic model as a replacement for the Fountain 10 because the paint on the metal body is bleeding causing the pump to lose seal and primer. There are no mounting holes, but they are the same as in the photo.Only 2 of the 6 holes from the old pump could be used.I also needed a nitrile block as the oil from the bilge was softening the flapper valve (in well 10) so it went through the hole. You can't order a pump with nitrile valves so I had to buy a nitrile kit and install it.The valve didn't tighten properly due to small screws so it didn't pump.Spent a lot of time with a simple replacement.