Review on 📺 Mounting Dream MD2268-MK Tilting TV Mounts for 26-55 Inch LED, LCD TVs up to VESA 400 x 400mm, 88 LBS Loading Capacity – TV Wall Mount with Innovative Strap Design for Easy Locking and Release by Sam Duppa

So I waited a few days to give my review. What I love about this product is that it does what it says on the tin (to mount your TV :)). It's pretty durable and not difficult to assemble at all. It comes with instructions and a small alignment tool. I would recommend that you buy this for the recommended TV sizes each version is designed to fit. It has a slight forward lean, a few degrees forward I think. The tilt is decent enough depending on how far the TV is from the bed and how far you place the TV. If it is above eye level, you may need a different product depending on the size of your TV. If it's at eye level and below, then everything should be fine. This took me about 1 1/2 hours because I wanted to make sure it was level and secure. Also, it took me a while to figure out how to properly work with a hand drill before I could get smooth. The 4th picture shows all the tools I used to assemble the TV. Necessary tools. Small hand drill v8-v10. Drill 5/32. Roulette. I suggest you don't get a TV mount as it's not as secure as putting it in cleats.) If you don't have that much cash you can use a tape measure instead of a cleat finder. Remember that each rosette is attached to a stud and each stud is 16 or 24 inches from the center. There are also hairpins, which are usually located in the middle of the room. Therefore, be careful with plumbing or electrical wiring. You can find information about concrete and brick walls on YouTube.