I bought these hoping that they would stick to the frosted glass on the back of the iPhone 11 as standard adhesive will not. First, the adhesive takes a significant amount of time to cure. After the initial installation I decided the curing time was excessive and started on it the next morning. It turns out you have to listen. The pop jack flew right out of my phone without a case and did the most damage. Ok, my fault right? I replaced my phone and attempted to install again, this time allowing enough time for it to cure and stick. After 3 full days of it being set I did a little push and pull test. It seemed to work. Less than a week later, however, the glue failed again. Luckily the pressure on my face while on the phone kept it from falling off again. I can't confirm how well they work on other surfaces, but they absolutely don't work on the new iPhone's frosted glass. 11 pers.
Radar detector Inspector Spirit
39 Review
Smart Column Yandex New Station Mini - smart column with Alice (with watch), black onyx
432 Review
SilverStone F1 Monaco S radar detector
82 Review
💨 LEMOISTAR USB Car Fan, Powerful 4-Speed Wind Circulation Fan for Vehicles SUV RV, Rear Seat Cooling Fan with Durable Hook - 5V USB Powered
38 Review
🎧 FARO Aviation Headset Converter: Low to High Impedance Adapter for General Aviation (GA) and Military Headsets
9 Review
✈️ Enhancing Aviation Safety: ASA-OVC View Limiting Device for Clearer Vision in Overcast Conditions
9 Review
ASA HS-1 Aviation Headset: Elevating Communication and Safety in the Skies
8 Review
🔍 MANN-FILTER W 811/80: The Optimal Oil Filter for Enhanced Engine Performance
11 Review