Review on 🔧 Hawking Accessories - Tweezers for Cleaning and Finishing by Adam Tidd

This is a set of tools useful in 3D printing. Most seemed to fit me. Cleaning needles come in a variety of diameters (and quantities), but the most popular 0.4mm size has the most. There is no size marking, but the needles of each diameter have a different length, which makes identification easier. Brushes for cleaning - There are brushes with nylon, brass and steel bristles. The quality is typical. - Scraper - this one surprised me because the edge was sanded which made it easier to slide under the bits stuck to the bed. Most printed lifting knives are not sharpened. The pipe cutter is designed for PTFE pipes and cuts straight and clean. Better than using a razor blade - tweezers - there are two tweezers that are marked ESD safe. I didn't find them to hold up very well though - pliers - a good clean cut - cleaning knife - that was the only part of the set that let me down, blades of various shapes, some curved but none were particularly sharp and all are cutting edges at the end of the tool - I'd welcome some with side edges.