Review on 💨 Enhance Air Flow with TYC 700239 Replacement Blower Assembly by Eric Avina

No need to remove the glove box to fit. The bottom cover has two rivets on both sides and a latch in the middle. Remove the rivets, open the glove box door and disconnect the shock arm by loosening the center clip. The bottom cover slides out. Another reviewer mentioned that the new compressor's nipple is a smaller diameter than the OEM compressor that the hose attaches to. It's a lot less. I had vinyl tubing, I cut a short piece and stuck it in the tubing, the OD and ID were close enough to get a tight and airtight fit. fan settings. I don't think it's noticeable while driving with the engine running.