I put these wires on the 4 cyl. 99 Ford Ranger installed. Yes, there are 8 slots. they are the recommended replacement kit according to Rock Auto dot com. I used Autolite AP104 forks - Amazon listing https://www.amazon.com/gp/product/B000C21IKM/ref=cm_cr_ryp_prd_ttl_sol_0. The driver's side connectors are a bit more difficult to remove - I would recommend removing the intake manifold: it's fairly easy - 6 bolts on bottom, 2 on top plus 2 for the EGR valve. There are a couple of small hoses under the top manifold that are a little tricky to remove and reattach, but there's nothing a regular wrench can't do - use long-nosed needle nose pliers and a long, thin flat head screwdriver. A gasket to the lower manifold was included in the gasket kit I received from Advance Auto ($11). it won't take more than a few hours even if it's your first time doing this work. the second time no more than 45 minutes do not forget lubricant for dowels and screws.
Upgrade Your Mazda MX-5 Miata With CravenSpeed'S USA-Made Door Bushings
39 Review
Replace Car Bumper Clips: GOOACC 100Pcs For Nissan, Mazda And Infiniti, Including Fastener Remover
33 Review
820Pcs Car Push Retainer Clips & Fasteners Assortment - Ford GM Toyota Honda Chrysler BMW Benz Nissan Subaru Audi Mazda
32 Review
Off-Road Fender Flares For Jeep Wrangler 2007-2018 JK & JKU Unlimited - Heavy Duty Flat Textured Steel Mud Guards In Black (Set Of 4) By Hikotor For Front And Rear Replacement (2 Or 4 Door Options)
47 Review