Review on 8 24UNF 2A Rotational Generator Accessories Household by Pedro Movie

. The product comes with a plastic net to protect the flow and it seems to have worked. Upon arrival, the threads were in good condition. The description of LxWxH is a bit confusing. The steel body of the probe is approximately 70.6mm long including the knurled area. The knurled section itself is 10.2mm [0.40 inch] and 12.7mm [0.50 inch] in diameter. The threaded portion of the probe is 3/8"-24 as specified. The built in cord length is 6 feet. The wires on my probe were red and black, not red and blue as shown in the pictures. The built in cord includes one Shield and a ground wire which are great for preventing signal interference.The probe I have has the shield not connected to the probe body.The jagged part of the probe shown in the 4th photo above can pose a problem when using it need to install reverse or when threading/tightening is difficult.I would have preferred turnkey flats but it really works.I adjusted the pin so that the notch on the lathe chuck was showing to test the dynamic response of the pin.I have seen a note about strength.The magnetic sensor has an independent power source because the field change of the internal magnets creates a voltage across the coils.The faster the displacement of the magnet field, the higher the output voltage, so these sensors have a higher voltage as the observed speed of the target increases. At a 2.54 mm [0.010 inch] gap I found 1.3 Vp-p at 700 events per minute and 14.4 Vp-p at 7500 events per minute, which is about what I expected. as advertised and I am satisfied with my purchase.