Header banner
Revain logoHome Page
Jason Vigil photo
1 Level
1339 Review
71 Karma

Review on πŸ”₯ E3D Hardened Nozzle V6 HS 175/400: Unbeatable Authenticity & Superior Durability by Jason Vigil

Revainrating 5 out of 5

Nozzle update for E3D V6

that originally had to be printed with glow-in-the-dark filament. At first this seemed to be causing the jam, but after troubleshooting I noticed that shortly after installing the nozzle, the filament got stuck in the middle of my thermal break, what a wild coincidence. After replacing it with a new thermal break, the nozzle prints perfectly. I understand that a steel nozzle should usually be printed at a slightly higher temperature, but I've found that in my case this isn't necessary. Maybe because I wear silicone socks? YMMV, I'll probably just leave this attachment installed forever.

Pros
  • Industrial & Scientific
Cons
  • I don't remember but there was something