They work and the design is good. Unfortunately they don't match any of the standard high end Marlin tables. If you use them at 200 degrees they will probably work for you using the standard NTC100K charts, but the temperatures vary by about 5-10 degrees and they will vary further and further as you go up. This is fine if you enter per-thread settings. The actual temperature doesn't matter as long as you just experiment and find the right setting. However, if you rely on manufacturer recommendations or have multiple printers, it is important to have accurate temperature reports. I ended up putting them in a drawer and laying out the Slice Engineering High Temp Printer. Too much hassle setting up a multiple thermistor setup to create your own tables. Maybe one day I'll get to it, but not today.
NEMA 17 Stepper Motor With Built-In 400Mm T8 Lead Screw For Improved RepRap Prusa I3 3D Printer Z Axis Or CNC Machine Performance - Iverntech
9 Review
BIGTREETECH TFT35 V3.0.1 Graphic Smart Display Controller Board For 3D Printer Ramps 1.4 RepRap 3D Printer Can Select Two Work Modes
13 Review
Pack Of 5 TMC2208 Stepper Motor Drivers For 3D Printers, DORHEA V1.2 Module With Heat Sink And Screwdriver For RepRap, RAMPS1.4, MKS, Prusa I3, Ender-3 Pro Controller Boards
19 Review
BIGTREETECH SKR Mini E3 V3.0 Control Board + TFT35 E3 V3.0.1 Graphic Smart Display Panel Board New Upgrade 3D Printer Parts For Ender 3, Ender3 Pro, Ender 3 V2
13 Review
π¨οΈ ANYCUBIC Printing and Engraving Filament Enhancer
3 Review
π¨οΈ Superior Monochrome Printing with the ANYCUBIC Photon Mono
3 Review
π¨οΈ ELEGOO Photocuring Printer: Enhance Your Offline Printing Experience with Advanced Technology
3 Review
ELEGOO Photocuring Monochrome 3D Printer: High-Resolution Prints in 129x80x160mm
3 Review