Good for shrink tubing. I would expect the plastic housing around the nozzle to melt fairly easily - it's made from ABS plastic which has a glass transition temperature (softens and deforms) just above 100°C (212°F) and is around 200°C (425°F ) melts (liquid). . ). The exhaust air should be just under 400 F, which is well above the temperature at which the ABS will warp. Because of this, the instructions say you shouldn't let it run longer than 8 minutes, but if the withdrawal is difficult at all, expect problems sooner.
STENCILIT® Herringbone Simple Wall Stencil For Painting XL 22X40 In Large Stencil For A Modern Wall Decor Herringbone Wall Stencil For Painting Large Pattern
35 Review
Cordiant Road Runner 185/65 R15 88H summer
72 Review
Efficient Plastic Razor Blades Scraper Tool For Scratch-Free Paint, Window, And Sticker Removal - 2 Pack With 100 Blades Kit
38 Review
XFasten Blue Painters Tape, Multi-Use, 3/4 Inches X 60 Yards (Pack Of 6) Blue Painters Masking Tape Bulk - Sharp Edge Line Technology, Produces Sharp Lines Residue-Free Wall Trim Tape
31 Review
Varathane 313835 Weathered Wood Accelerator, Quart, Gray
17 Review
Upgrade Your Paint Spraying Game With HomeRight'S 27 Oz. Container & Lid For Finish Max Sprayer
9 Review
🐝 Daddy Van's Unscented Beeswax Furniture Polish: Non-Toxic, Odorless Wood Wax for Nourishing Furniture, Antiques, Cabinets, and Butcher Block
9 Review
SamaN Interior Water Based Wood Stain - Natural Stain For Furniture, Moldings, Wood Paneling & Cabinets (Black TEW-108-12, 12 Oz)
28 Review