Review on 12X9X3 Inch Granite Surface Plate With No Ledge - Perfect For Precision Measurement by Rahman Lassiter
It's definitely flat
I'll admit, I was a bit concerned at first. I laid my straight edge across the surface and could see light shining through underneath. However, I used my smallest feeler gauge (0.015" / 0.04mm) and couldn't slide it under the straight edge anywhere.Is it flat within .0025mm as they claim? Probably not. It's definitely better than 0.04mm though and that's perfect for my needs.
Pros
- For General Inspection Work Throughout The Shop
Cons
- This surface plate may require additional accessories like clamps, gauges, and indicators to be properly used, which can be an added expense
New products
Comments (0)
Top products in 📏 Calibration
🔌 Enhanced Connectivity with Fluke IR3000FC Infrared Connector
2
6 Review
Enhanced Performance: Fluke BP190 Rechargeable Capacity ScopeMeter - Revolutionizing Test and Measurement Efficiency
4.4
5 Review
📏 Accurate Truweigh Calibration Weight Precision 6 Piece Set: For Precise Measurements
3
5 Review
🔧 Calibration of American Weigh Scales 500WGT for Optimal Performance
5
4 Review
