Review on Touchscreen Navigation Protector Anti Scratch Resistant by Jerry Amos

It was easy to apply using masking tape on top to keep it level when removing/peeling the clear mask. Here are the steps I follow.1. First, put the screen in screen cleaning mode and clean the screen with microfiber and alcohol. Make sure there are no streaks.2. Align the protective film at the top and stick a small masking tape in the middle.3. Adjust the screen protector and stick the masking tape along the full length of the screen protector, covering the top of the screen and the back.4. I lifted the protective film from the bottom, cleaned and blew out any airborne particles and now everything is very clean. Remove the transparent protective film facing the screen on the protective film.6. The protective film slightly bent in the upper part and began to press against the screen and go down. This means that no air bubbles remain underneath. Don't be afraid if you need to keep picking up and applying again.7. If there are small air pockets, start pushing them to the edges and outwards. No tools were needed for this. And you're done. I had no particles or air bubbles at all. Alignment was pretty good, maybe 1mm up/top right. Now it's almost invisible. I had no problems using the screen right away, no phantom touches or usage issues. I don't see it reflecting more than the main screen. I should check fingerprints in a few days and see how much he collects. Not sure if the 9H rating and all is true, but I hope this helps save the screen from minor crashes!