These inserts are of a higher quality than other inserts I have tried (jegs) as the top edge is 90 degrees to the insert and the bottom has a large 45 degree bend, they are stiffer and less likely to bend. The jegs plates I had previously were curved about 1/8 inch from side to side making it difficult to get the right toe measurements/adjustments. That being said, mine had 3 problems: 1) A magnet used to hold the bands was knocked off. They are simply glued on. 2) The 2 places where the measuring tapes go into the grooves were bent - apparently this was due to some sort of bump - but the box looked in good condition so I don't think it's delivery related - it probably happened at the factory. 3) Fewer problems - but the tape measure looks cheap and the plastic "handles" (not shown in the photos - probably for a good reason) are very stiff and just annoying. I'll probably remove them - they should be less rigid or a completely different material - like nylon. save with great effort and no return (I had to do the alignment the same weekend they arrived).
🔧 OEM TOOLS 27213 Master Wheel Hub & Bearing Remover and Installer Kit, Back and Front Wheel Bearing Puller and Installer Kit, Back and Front Wheel Hub Puller, User-Friendly
8 Review
🔧 OEMTOOLS 27308 Ball Joint Separator: Adjustable from 1-1/8" to 2-1/8", Perfect for Common Ball Joint Sizes, Enhanced Steel Separator Mechanism with Black Oxide Pins
9 Review
OEMTOOLS 24429 Ford 3-Valve Spring Compressor: Efficient Tool for Ford Valve Spring Compression
9 Review
🔧 Astro Pneumatic Tool 7865: Ball Joint Service Tool + 4WD Adapters
8 Review