Review on High-Performance MSI MPG X570 GAMING PLUS Motherboard: AMD AM4, PCIe 4.0, DDR4, SATA 6Gb/s, M.2, USB 3.2 Gen 2, HDMI, ATX by Boyan Kolev ᠌

The decision to try out the RAM was made right after it was unpacked. I'd rather not have to insert "on the dark" and tighten the motherboard screws again. The RAM latches are only on one side, thus the plate has to be "hooked" from the bottom up, so I set it on some foam and tried to enter it. Adding RAM is not a simple process, so I think this is a bad call. In short, everything started to crackle, and I put off dealing with it until the mother was fitted in the case because of concern that the tracks would just shift away from the textolite. Additionally, I did place my mother in the case, but she got up crookedly; there was a gap of a millimeter between the upper right corner and the rack, despite everything lying on all the other racks. I double-checked the case and my own sphericity for problems, but both were fine. It was decided not to tighten the bolt in the top right corner. If you don't squeeze the socket on the rear with your fingertips, the textolite 50/50 will crack. This is how I inserted the 24Pin bus. The RAM slots appear to be made of metal, but whatever it is, they managed to scratch brand new RAM. There were a lot of inserts, and they all rattled and crunched through with no problems at all (you'll see why in a bit). As was to be predicted, the southbridge propeller generated the most noise. This is very exciting: D The icing on the cake is the non-functioning fourth RAM slot (I wouldn't throw away my marriage if it weren't for that slot's connection to the dual-channel). Two HyperX Fury 32GB dice were placed into the fourth slot, but the mother still refused to boot. A wild non-singer was waiting for me when I examined the soldering of RAM slots on the other side. I was duped by the false promise of illumination from the back; I expected the red stripes to illuminate, but in reality, only the lower lettering Gaming Plus lights up. KARL with a rainbow of LEDs on the rear! They should not have backlit the MSI logo, but they later came to regret doing so. Finally, I'd want to express my gratitude that nothing was burned while I returned this trash to the store.