Review on 🔧 Vtopmart 50 Wood Oscillating Multitool Quick Release Saw Blades: Compatible with Fein, Porter Cable, Black & Decker, Bosch, Craftsman, Ridgid, Ryobi, Makita, Milwaukee, Rockwell by Badazz Webb

Update: I'm using these today when cutting soft poplar. A thin curse is good because it's a bit quicker in the juicer plus, but unfortunately they don't stay sharp for very long. I used 2 blades total to make 6 cuts 3" wide and 1" 3/16" deep. No nails or staples. I didn't really have to change the blade because I just sat and ran it for a while let it pass eventually but as soon as it started smoking i stop and change the blade yes it's a pretty good price but looks like i'll be using those two high quality blades i usually buy This makes these blades about 20% cheaper Maybe I'll change my mind later but today it's not a waste of money Original post: Honestly I haven't tried them but the description shows they are thicker than the competition. INTEGRA brand - .034". Master is .040", which is much thicker than both! These VTOPMART blades only come in .026" thickness. Sometimes thinner is better because they cut faster, but when you say they do are stiffer and thicker than most, it's better to be that precise. Honestly, you can't get much thinner than .026 inches, so how can you say you're fatter than most? If it were a little thinner it would overheat when flexing within a few seconds of use. If I use these and they outperform Craftsman and other brands I have I will edit my review. Until then, I'm a bit disappointed that I bought two sets thinking they were thicker. I was raised not to say things that aren't true. Let's see where this takes you.