Header banner
Revain logoHome Page
Mohammed Prude photo
Singapore, Singapore
1 Level
712 Review
52 Karma

Review on πŸš— Enhanced 12V LED Flush Mount Light Bolt by Oznium - Ideal for Bumpers, Grilles, Car Interiors, Dashes, Ambient Lighting, and Motorcycles with Sleek Aluminum Housing & Screw Nut (6 mm Black, Red LED) by Mohammed Prude

Revainrating 5 out of 5

Outstanding LED Light

I have a habit of not hearing the blink if the curve wasn't sharp enough. Proof "my Toyota RAV4. I was looking for small yellow LED lightbulbs and came across them. They seemed to fit all the needs I had in mind. Installed them just above my audio tweeters on each door (usually behind the side mirrors in the doors). Wires are routed and connected to each turn signal (left and right). Now I can see the turn signal light unless I overhear the turn signals still on. I'm deaf (75%) and I probably should I need to do it earlier, you no longer have to drive on roads with the turn signals on, the idea was mainly for daytime use, because sometimes flashing arrows shine on the cluster body (the position of the steering wheel and hand blocks most of the view). But also at night the light is perfect Not too bright and the light diffusion is perfect Will definitely buy this brand again for my project Deaf Proof v.2.0

Pros
  • Simply drill a 11mm (approx. 7/16") diameter hole, run 3 feet of 22 AWG wire, insert the LED, tighten 2 locknuts, then connect +/- (red/black ground). Simple two-wire connection means it can be installed in minutes. No need to upgrade backup!
Cons
  • Requires socket