While initial thoughts were positive due to the solid construction and overall spacious layout, I found that the pins on the board are not 100% picking up signals as they should. I built a simple full wave rectifier circuit using a few diodes and a resistor, but I saw a strange waveform on the oscilloscope. The result shown in the left image is the same as the output but was incorrect. It wasn't until I put my palm on the circuit and pressed all the components that the output became what it should have been, as seen on the right. After I stopped clicking on the components, the waveform went wrong again. I recreated the circuit on another board and it worked fine. Most likely, the reason is bad contacts on the board.
REXQualis Comprehensive Starter Kit with Arduino MEGA 2560 & Detailed Tutorial for Arduino IDE Compatibility
11 Review
🎁 Ultimate BBC Micro bit Sensor Starter Kit: Keyestudio 37-in-1 Box with Tutorial, Compatible with V1.5 & V2, Gift for Kids and Adults (Microbit Board Not Included)
11 Review
LAFVIN Super Starter Kit for Arduino R3 Mega2560 Mega328 Nano with Detailed Tutorial - Compatible with Arduino IDE
11 Review
🌐 MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
M.2 Screw Kit: Easy Mounting for NVMe SSDs on ASUS Motherboards
19 Review
Glarks 660 Pieces Phillips Assortment Motherboard
10 Review
uxcell 3.5" HDD Screw Black 200pcs for Computer PC Case - Flat Phillips Head - 6#-32 - Hard Drive Fasteners
10 Review
Comprehensive 500pcs Laptop Screw Kit Set for 🔩 IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review