I have been making my own LED lights using 3D printed packages for a number of years and have recently tried my hand at making ultra thin lights using SMD LEDs and some stripe plates. I was thinking of a lantern-like design with four circuit boards lined with SMD LEDs for lighting. These boards give me more connectivity so I think they will be helpful when deciding on the main design and other factors. I inspected several boards to make sure the circuitry was intact and all the boards inspected turned out to be fine. Aside from messing up soldering the LEDs onto these boards, I don't expect any problems with them.
Gikfun Screw Shield Expansion Board: Enhance Arduino UNO R3 with the EK7007 Add-On
11 Review
REXQualis Comprehensive Starter Kit with Arduino MEGA 2560 & Detailed Tutorial for Arduino IDE Compatibility
11 Review
Vilros Raspberry Pi 4 4GB Complete Starter Kit - Black Fan-Cooled Aluminum Case for Heavy-Duty Performance
12 Review
π MCIGICM 2 Channel DC 5V Relay Module: Optocoupler Low Level Trigger Expansion Board for Arduino UNO R3, DSP, ARM, PIC, AVR, STM32, Raspberry Pi
11 Review
Glarks 660 Pieces Phillips Assortment Motherboard
10 Review
Comprehensive 500pcs Laptop Screw Kit Set for π© IBM HP Dell Lenovo Samsung Sony Toshiba Gateway Acer
12 Review
uxcell 3.5" HDD Screw Black 200pcs for Computer PC Case - Flat Phillips Head - 6#-32 - Hard Drive Fasteners
10 Review
MacBook Retina 13-inch (A1425, A1502) and π© 15-inch (A1398) Bottom Case Screw Set with Pentalobe Screwdriver
11 Review