Used to replace one of the A/C fan motors in the Jaguar XJ6 Series 1. It has the correct shaft diameter (1/4 inch) but the machined flat surface is not deep enough to accommodate the original cage fan which needs to be reused as nobody seems to make a 5 inch cage in the world. Either the squirrel cage fan opening needs to be modified or the shaft needs some sharpening to make it work. I machined .030 from the plane because I didn't want to risk damaging a 50 year old nylon fan. After that and some creative bracketing to fit it into the original flange, it worked flawlessly. This engine seems a little noisy and underpowered, but it's light years better than the dying engine I'm replacing. If I had to do it again I would use the longer Four Seasons fan motor - 35431 - which is more expensive but has the same diameter, only longer. I suspect it could be stronger as longer probably means a bigger armature and longer magnets so it could be stronger. However, it's impossible to know since the Four Seasons catalog doesn't say anything just about rev size.
820Pcs Car Push Retainer Clips & Fasteners Assortment - Ford GM Toyota Honda Chrysler BMW Benz Nissan Subaru Audi Mazda
32 Review
Upgrade Your Mazda MX-5 Miata With CravenSpeed'S USA-Made Door Bushings
39 Review
Off-Road Fender Flares For Jeep Wrangler 2007-2018 JK & JKU Unlimited - Heavy Duty Flat Textured Steel Mud Guards In Black (Set Of 4) By Hikotor For Front And Rear Replacement (2 Or 4 Door Options)
47 Review
Replace Car Bumper Clips: GOOACC 100Pcs For Nissan, Mazda And Infiniti, Including Fastener Remover
33 Review