Review on Enhance 3D Printing Efficiency 🖨️ with Creality Original Platform Sticker 235X235Mm by Richard Cuneo

Repeat what others have said. The prints stick to this material like glue. I ignored what the other reviewers said assuming they were doing something wrong since the standard magnetic bed that came with my Ender 5 didn't have these issues and also because I mostly print PLA. God I was wrong! Even with PLA, the print stuck to the surface and was impossible to remove without scraping it with a HARD parts scraper. Eventually the seal was defaced and the bed surface damaged. Solution: USE REMOVE LAYER! I only use purple glue stick (the kind that kids use in elementary school). When I wear the layer across the bed in one go, the details immediately emerge. When this problem is solved, the adhesion is amazing! I've tried PLA and PETG and had no problems. Combine this with a spring steel printing surface and you have the best printing surface! After a few prints I clean the surface with dish soap and water, apply another layer of glue stick and I'm good to go! Highly recommended! Just do not use without a separating layer!