Review on 🚲 Visnfa Bike Phone Mount - Anti-Shake & Stable Cradle Clamp | 360° Rotation Bike Phone Holder for iPhone, Android, GPS & More | Fits Devices from 3.5 to 6.5 inches | Essential Bike Accessories by Jonathan Bennett

For a cheap mount it's pretty good. I only have one complaint (it's unusual for me. Usually there are several) a bit small. I have I have a Trek Verve and the diameter of the handlebars increases towards the middle. I've only recently bought a bike but while shopping I noticed that most bike manufacturers did the same thing with this design as Trek did. I had to get the mount closer clamp to the shifter. Not a show stop but I would have preferred the position closer to the stem. Oh well! You can't have everything. Also, the mount came with three different sized neoprene pads that fit into the handlebar clamp and three different sized pads Bracket on the inside of the actual bracket I have an iPhone X with a slightly thicker case than the you Cut and this mount fits perfectly. With the choice of cushioning I could easily mount the phone without a case or with a thick Lifeproof or Otterbox case and the mount could accommodate both. The phone falls into the cradle and with a few clicks the four corners close and snap into place. The phone is great with no screen clutter, sleep/wake or volume buttons, speaker or charging port. When you're done with your ride, simply press the quick release button on the back of the mount and the four corners will pop out of the phone. Just make sure you're holding your phone when you let go. A shock absorber will most likely prevent the phone from sliding down, but it all depends on what angle you set the phone at. Mine is at about a 15º angle to the plane so my phone doesn't fall out when I release the button. Only time will tell how well it will hold up and wear down. As it stands I would give 6 stars if the handlebar clamp was larger or two different clamp sizes were included.