Review on 🏭 Enhanced Industrial Machinery: OrangeA 13200 Lb Rotation - Maximize Efficiency! by Daniel Shivashankar

had to buy 4 pieces. 3 came to me, one was destroyed on the way and the money was returned to me. In general, the design on them is quite decent. It will most likely get the job done. I have a problem with packaging and assembly. The first came, were assembled. But I turned the platter up and the bolt holding it loosened, spreading the end load of the 5/16" bearings all over the magazine. Managed to get all bearings back and everything was fine. The second appeared later that day, and the screw was loosened. So I pulled it out, smeared it with Loctite and twisted it. There shouldn't be any problems with that. Number 3 appeared a few days later. The packaging was a little shabby, but acceptable. I get up and hear something rattling around. Well the turntable on this one came off on the way to my house or something. All but 4 bearings are gone as is the bolt holding it on. So now I have to make a new bolt and find a bunch of loose 5/16" ball bearings somewhere as I don't have time now to get a replacement around here before one of our mills has to be moved. It's okay since I'm a car company own but it's annoying as hell having to do that shit again you get what you pay for so take it with a grain of salt this is probably one of the cheapest skates out there so there it is think at the Just buy on them. These are cheap Chinese skates and the construction and packaging reflects that." Edit: After trying to use them, I'm not impressed. With their help, we attempted to build a 7,000 pound CNC machine We couldn't even get it to roll. We just had to rotate the windmill about 45 degrees and roll it away from the wall and it couldn't even do that. We ended up using a pallet jack and did a lot of shitty things to make it work. Overall I am very disappointed in them. And all this on a relatively smooth concrete floor.