Review on 🏭 Creality Enclosure: Temperature-Controlled, Soundproof, and Dustproof Solution by Devon Holmes

Great product that works as intended! My Ender 3 V2 fits in great as it leaves some room including the coil. Tip: Be prepared to re-level your bed, as it will likely be impossible or nearly impossible to lift and maneuver the printer in without upsetting its calibration. Probably obvious; I just want to warn anyone interested. Mine rotated over 1/16" after entering the case, which requires some agility as it doesn't slide in easily. Other precautions should be taken, e.g. B. Removing the spool of filament before installing the printer in the case. Probably obvious, but also easy to overlook. The only reason for 4 instead of 5 stars: The power cord hole is in the front left bottom of the case, not in the back! With such a short OEM power cord that comes with the cable gland location is extremely inconvenient for the printer. Of course, it can easily be replaced with a longer cable, but why? When I put the cable back behind the table, it doesn't touch the floor even close to the table. The power cord enters the back of the machine so I don't know what on earth they found to put a feed through hole near the front of the guard. Very unfortunate location. I would deduct 2 stars just for that because it's so ridiculous, but other than that the case is VERY nice, very thick and very well made.