Review on ACDelco 45G0876 Professional Suspension Stabilizer by Eric Dubreuil

Well it's hard to say how good they are as I only posted them today but they fit my 2001 Honda Civic Coupe perfectly. They are cut off at the sides to allow them to be slid onto the stabilizer, making installation easier. To install them, you need to raise the car on a jack, and then climb under it. Each bushing is held in place with a curved plate and 2 screws. You have to fully unscrew 2 bolts on one and loosen the other 2 to hold the bar up and make hub changing easier. Be sure to pay attention to the direction they are pointing. For me the cut was facing the front of the car. They fit too, they were a bit smaller than the ones I installed. I paid attention to the following: 1) cleaned the stabilizer bar and bushing 2) smeared some silicon grease into the bushing and bent bracket 3) smeared antifreeze - tighten bolts 4) carefully screw everything back on, let's see how long you last but are so far they are quiet and seem to be doing their job.