Review on π 2 Pack Power Distribution Block for Car Audio Amplifiers - 0/2/4 Gauge Input to 2/4/8 Gauge Output by Chris Knight
Just what you need
Everything is OK except for one thing: the screws that hold the cover to the base are removed immediately. To solve this I simply worked my way down to a 1/2" hole drilled ONLY through the top plastic above the adjustment screw of each bottom connector - this way I can fully back out the screw if needed - which they do , to fit the 0 caliber.
- PDU, run up to three 4 gauge or 8 gauge wire to the amps. PDU, can also be used to combine the ground lines of multiple amplifiers into a single ground point
- Everything is OK
New products
Comments (0)
Top products in π Vehicle Electronics Accessories
StarTech.Com HDMI To VGA Cable β 6Ft 2M - 1080P β Active Conversion β HDMI To VGA Adapter Cable For Your VGA Monitor / Display (HD2VGAMM6)
38 Review
π¨ LEMOISTAR USB Car Fan, Powerful 4-Speed Wind Circulation Fan for Vehicles SUV RV, Rear Seat Cooling Fan with Durable Hook - 5V USB Powered
38 Review
Smart Column Yandex New Station Mini - smart column with Alice (with watch), black onyx
432 Review
Radar detector Inspector Spirit
39 Review
Another interesting products
βοΈ Enhance Your Aviation Experience with the David Clark H10-13.4 Aviation Headset
9 Review
π§ FARO Aviation Headset Converter: Low to High Impedance Adapter for General Aviation (GA) and Military Headsets
9 Review
πΊοΈ CARRVAS GPS Navigation System for Car, 2021 MAP 7inch Truck GPS Navigation, Spoken Turn-by-Turn Directions, Speed Warning, USA, Canada, Mexico, Lifetime Maps Update
9 Review
ASA HS-1 Aviation Headset: Elevating Communication and Safety in the Skies
8 Review