Review on 🐒 Climbing Monkey Climbing Holds - Set of 25 Rock Climbing Grips - Complete with Premium Mounting Hardware - High-Quality Climbing Rocks for DIY Rock Climbing Wall by Lancy Rakesh

TLDR. Depending on your needs, you may need to look for shorter screws. The pens feel decent, albeit a bit smaller than the original set. Although my kids ages 3-9 seem fine with it. One of the items in the description reads "INCLUDED IN INDUSTRIAL EQUIPMENT PACKAGE" with zinc plated steel "2.5" hex head screws." While this may be true, it may not meet your needs as much as it does mine. I replaced a stone wall on a playset that used 1" x 6" boards. Most smooth boards are about 1/8" too small, so I'm actually dealing with boards that are about 7/8" thick. Clamps with washers are about 1/2" thick (where the bolt goes through). Since the "weld nuts" (T-nuts) are flush mounted, this leaves about an inch or so on the back. The existing brackets used short bolts that didn't protrude from the t-slot at all but I couldn't reuse them.I was worried the little ones would probably hit their heads on thirty or so exposed bolts.I did a bit of searching to see if I could could find a set with shorter bolts but that seems to be quite common. I figured worst case scenario I'd trim off the excess. I looked around and saw these bolts cost about $4 each (Ace, Lowes, Home Depot ).I ended up finding something on another site.I swapped them out and was very surprised to see how rusted and slightly rusted the ones that came with are in less than three weeks.