Review on 🔧 Optimized Stainless Engineering Architect for Machinist Engineers by Dakota Afzalian

Inaccuracies. Both rulers that I received as a pair had the ends torn off at both ends. One is almost 1/64 inch. This is very bad for the Machinist/Engineer line. The markings also didn't look like they would hold until the engraving was deep compared to other 6-inch rulers from other manufacturers. I have used in the past. I wasn't expecting a Starret or Mitutoyo but at least a usable line. If the ends are not square, one side will be different from the other. If they stayed too long I could sand them flat enough for my use, but the really bad end on one of them was almost a 64th short so they're coming back.