Review on JFJ Maple Skateboard Decks: Boost Your Skating with Double Tail Design, Lightweight Construction, and Free Grip Tape by Doug Darling

Half done. The bottom is closed, but the top is not. They are deformed. On one side, the concavity is higher on one side than the other. They are drilled according to the "old school" pattern. So if you don't have double perforated rails, you're drilling holes in the front and weakening the deck even more. The edges are not rounded, just sanded to break the edge a bit. But not finished like a real board should be. Likewise. The grip tape is a fancy thin material that is twisted and then flattened. Make fold lines every 1.5 inches as you unfold to tighten. And the tape is also die-cut with rounded edges like a 9x32 inch board. waste of money. They cut every corner they could. They bought the remaining old unabridged blank seconds and tried to make a quick buck. All they did was cut them out, drill the wrong pattern, then sand them down and then just scrape the floor. 1* because I can't give less.