Review on Dritz 44352 Condensers White 4 Pack by Lori Aguirre

I used these cable ties to replace the original cracked and falling apart tie rods on a set of heavy 6ft mini blinds. Each curtain is stretched with thick cord, allowing you to raise, lower, open and close the mini blinds. Each mini blind has 4 thick cords that run through the top draw hole. So I had to make sure the top cable hole was wide enough for the cable to go through. The Dritz #44350 cable tensioners fit very well and it took about a minute to tighten the cable. The 4 strand thick cords easily go through the large diameter hole, I just tied the cords in the drawbar. Nothing fantastic. They work perfectly and I am very happy with them. Each rod is made from a heavier/thicker material-like plastic than originally shipped with my blinds. I measured a 1-3/4" length of the drawstring from the top to the bottom of the drawstring and a 3/4" (OD) width of the hole at the bottom of the drawstring. The inner diameter of the bottom connection hole is 5/8" and the inner diameter of the top hole is 3/16". This was enough to run 4 thick strings through the hole. I hope this helped. to pass 4 thick cords through the hole. I hope this helped. to pass 4 thick cords through the hole. I hope this helped. Each rod is made from a heavier/thicker material-like plastic than originally shipped with my blinds. I measured a 1-3/4" length of the drawstring from the top to the bottom of the drawstring and a 3/4" (OD) width of the hole at the bottom of the drawstring. The inner diameter of the bottom connection hole is 5/8" and the inner diameter of the top hole is 3/16". This was enough to run 4 thick strings through the hole. I hope this helped. to pass 4 thick cords through the hole. I hope this helped. to pass 4 thick cords through the hole. I hope this helped. Each rod is made from a heavier/thicker material-like plastic than originally shipped with my blinds. I measured a 1-3/4" length of the drawstring from the top to the bottom of the drawstring and a 3/4" (OD) width of the hole at the bottom of the drawstring. The inner diameter of the bottom connection hole is 5/8" and the inner diameter of the top hole is 3/16". This was enough to run 4 thick strings through the hole. I hope this helped. to pass 4 thick cords through the hole. I hope this helped. to pass 4 thick cords through the hole. I hope this helped. to pass 4 thick cords through the hole. I hope this helped. to pass 4 thick cords through the hole. I hope this helped. to pass 4 thick cords through the hole. I hope this helped. to pass 4 thick cords through the hole. I hope this helped.