Review on 🖨️ Enhance 3D Printing Precision with BIGTREETECH Direct BLTOUCH Extension Controller by Shane Minter

Well this cable is just what I needed. Creality's BLTouch showed up with cables routed. So I ordered this bundle of cables. Came with split cable. Two on the stop and three on the sensor itself. So I looked at the cables and they were misaligned when connected to the SKR Mini E3 V2. The first three had to be grounded, 5V, input. They weren't. The end of the Z-Stop cable is properly connected. So no problem. After swapping out the DuPont connector and placing the wires in the correct order, I compiled and ran the firmware. It worked perfectly. My reason for not giving five stars is that the cable wiring failed. If anyone thinks this is going to be plug and play, there's a smoking board waiting for them. Research, research, research. Check the wiring and then connect things first. Confirm before adding food. This is a great harness, but the wiring must be done to match the sensor.